Home / All / Valves / Ball valve /

PQ47H Trunnion Mount Circular Sector Metal Seal Ball Valve

PQ47H Trunnion Mount Circular Sector Metal Seal Ball Valve

PQ47H Trunnion Mount Circular Sector Metal Seal Ball Valve
CategoriesBall valve
BrandGARLOS
ModelPQ47H
Seal Test Pressure1.1/1.76/2.75MPa
Strength Test Pressure1.5/2.4/3.75MPa
StructureTrunnion mounted, Straight flow
SealMetal seal
Disc typeEccentric, Circular sector
Update TimeMar 29,2024
Detail Information

PQ47H is trunnion mount circular sector metal seal ball valve, with the advantage of low manufacturing cost, low flow resistance, reliable sealing.


Suitable for any medium without suspended solid. It could be installed in any direction, but the medium should enter the valve body against the valve seat and apply pressure to the eccentric circular sector semi ball(positive pressure). Eccentric circular sector semi ball valve for medium with suspended solid should be installed as shown in the picture below:


Nominal Pressure

1.0MPa

1.6MPa

2.5MPa

Nominal Diameter

DN100-1200mm

DN100-1000mm

DN100-800mm

Test

Pressure

Seal

1.1MPa

1.76MPa

2.75MPa

Strength

1.5MPa

2.4MPa

3.75MPa

Valve Body Material

HT200

QT450-10

WCB

Sealing

Material

Seat

NBR  2Cr13

2Cr13

Zg12CrMo1G

Crown

Coat 1Cr18Ni9Ti

Coat 1Cr18Ni9Ti

Coat 1Cr18Ni9Ti

Suitable Temperature

-15-+80

-29-+200

-29-+300

Suitable Medium

Water, sewage, oil, ash and other non-corrosive liquid

Actuator

Manual, ElectricPneumatic

Eccentric circular sector semi ball is driven by upper shaft to rotate by 90 degrees around the upper and lower shafts. When rotating clockwise, the semi ball moves into the valve seat, under eccentricity, eccentric circular sector semi ball presses on valve seat, to seal, the valve is closed. When rotating counterclockwise, under eccentricity, eccentric circular sector semi ball leaves valve seat, turns 90 degrees to fully open the valve. Because of eccentric structure, valve opening and closing torque is small, flow area is large, flow resistance is extremely small.


FOR DN which is bigger than 600mm, bypass valve is suggested to installed in pipeline




Please send your message to us
*Email
Tel
*Title
*Content
Upload
  • Only supports .rar/.zip/.jpg/.png/.gif/.doc/.xls/.pdf, maximum 20MB.

skype us

Skype: garygarlos

call us now

+86- 134 5600 7377

request a quote

Click to send feedback

NEWSLETTER
follow us